Now we are ready for replace the damaged display with a new one. Separate the display assembly from the laptop body. Remove three more screws securing the right hinge. There is a metal bracket attached to the antenna cable. Remove three screws securing the left hinge. Open up the display and place the laptop upside down on the edge of the desk. There are six T8 screws securing display hinges. Pull the cable out of the connector by the black tab.Īfter all cables are unplugged and unrouted we ready to remove the display. Unlock the connector by lifting up the metal bracket. Now we are going to disconnect the display screen cable. Unroute antenna cables from the guided path in the top case.
Where to buy clean my mac 3 Bluetooth#
Unplug antenna cables from the Wi-Fi Bluetooth card. Just lifting up the left side should be enough to release the cable. It’s not necessary to remove the board completely. TIP: if the cable got stuck under the MagSafe board, remove one screw securing the board and lift it up a little bit. I use tweezers to push the webcam cable plug out of the connector. Pay attention which screw goes where.ĭisconnect the MagSafe board power cable from the logic board.ĭisconnect the webcam cable. Pull the cable from the connector (yellow arrow). Unlock the connector by lifting up the locking tab at a 90 degree angle (red arrow). Separate cable from the fan and remove it.ĭisconnect cooling fan cable from the logic board. The flex cable attached to the fan by adhesive tape. In order to unplug the flex cable, lift it up from the connector using plastic pry tool.
0 kommentar(er)
